// Garages

Garages - Road Service

When providing roadside service, what should I remember about traffic control? Survey the area for any hazardous conditions, especially where other vehicles may be driving nearby (e.

foot protection hand protection high-visibility clothing

When providing roadside service, what should I remember about traffic control?

requirement Survey the area for any hazardous conditions, especially where other vehicles may be driving nearby (e.g., merging lanes, intersections, on-coming traffic, etc.).
requirement Use ample warning lights or pylons around the pick-up area.
ppe Wear high-visibility personal protective clothing, especially in low-light or dark conditions.
ppe Wear protective footwear.

When providing roadside service, what should I remember about supplying fuel?

context Label containers as required by regulations.
context Carry fuel in a labelled, approved portable container fitted with a tight cap and a pouring spout.
context Maintain contact between the container and the filler opening when refuelling a vehicle.
context Use separate containers for handling gasoline and diesel fuels.

What should I know about towing another vehicle?

requirement Check the type of transmission on the vehicle and follow the manufacturer's instructions for towing front-wheel drive, rear-wheel drive or four-wheel drive vehicles.
requirement Tow rather than push a vehicle whenever possible.
requirement Avoid the use of flares in case of fuel leaks.
requirement Turn on the disabled vehicle's 4-way flashing lights and, if available, place the tow extension stop/turn signals in a visible place on the vehicle being towed.
requirement Outfit service trucks with emergency equipment, warning signal devices, and wheel chocks.
requirement Equip service trucks with a properly rated fire extinguisher.
requirement Post the maximum hoisting capacity of the towing unit on the winch mast. Do not remove or paint over information on the manufacturer's data plate.
requirement Leave at least three wraps of the cable on the winch.
requirement Operate hoist controls away from the winch drum, travelling cables, and sheaves. Keep bystanders away.
requirement Make sure wheel lifts extend far enough to have clearance when turning.
requirement Be aware of electrical powerlines when the boom is extended.
requirement After a vehicle is rigged, do a double-check. Make sure all cables or connections are secure before driving.
requirement Make sure any locking pins are properly engaged.
ppe Wear appropriate gloves to prevent cuts from cables and sharp objects.
requirement Do not straddle the tow cable.
requirement Do not work under a vehicle suspended by a tow truck. Place jack stands or blocking under the frame.
requirement Do not exceed the towing capacity of the truck, or exceed the limits of the cables, chains, tow bars, etc.

What are some items to inspect on the tow vehicle?

Inspect weekly: Inspect monthly:

context control mechanisms for poor adjustment or excessive wear
context safety devices for poor adjustment and proper operation
context hooks for cracks or excessive deformation
context tire pressure and tread
context structural parts for deformities, cracks, or corrosion
context sheaves and drums for cracks or wear
context pins, bearings, shafts, gears, and locking devices for cracks or distortion
context cables for excessive wear, corrosion, broken strands, severe kinking and improperly applied, cracked, or corroded cable connections

What are some safety tips for priming a carburetor?

While uncommon in most vehicles, if priming a carburetor, ALWAYS: Refer to OSH Answers Garages - Tire Precautions for information on changing tires and Garages - Batteries for information on charging and boosting batteries.

ppe Wear protective gloves, long sleeves, long pants, and eyewear.
ppe Pour a small amount of fuel or starter liquid into the carburetor air intake with the engine stopped. (Use a small container that holds around 2 oz. or 60 mL - do not use a regular-size fuel container.) Replace the air cleaner and lower the hood.
requirement Do not spill gasoline on hot engine parts.
requirement Have a fire extinguisher (Class B for flammable liquids) handy in case of a fire.
administrative Stand back while the engine is being started to avoid the risk of burns. Repeat the procedure if necessary.
requirement Do not try to start a stalled vehicle while pouring the fuel into the carburetor. This action may cause a flashback and ignite the fuel in the container.