How should you mount an abrasive wheel?
- context Follow the manufacturer's recommendations when handling, grinding, maintaining and storing abrasive wheels. An operator must be fully trained and instructed in the safe use, care, and protection from abrasive wheels before use.
- context Lock out and tag out all machines before making any repairs. Disconnect machines from their power source before changing the abrasive wheel.
- context Ensure you have the correct type and size wheel for the machine by checking the markings on both.
- context Select the proper abrasive wheel and machine for the job. Consider the material, the finish quality, and the contact area of the wheel.
- context Check and make sure that the machine spindle speed is not greater than the maximum operating speed marked on the wheel.
- context Examine the wheel for cracks or chips (visual inspection) to ensure the wheel is in safe condition and perform the "ring test." Replace the wheel, if faulty.
- context Inspect the machine and its guards. Do not use a damaged machine, or one with the guards damaged or removed.
- context Do not force a wheel onto the machine spindle or change the size of the mounting hole.
- context Maintain even pressure from both flanges against the sides of the wheel. Check flanges with a straight edge. Worn or warped flanges must not be used.
- context Maintain a clearance (undercut relief) of at least 3 mm (1/8 in.) to prevent pressure on the wheel near the hole.
- context Check the surface of the abrasive wheel and flanges to ensure that no particles are present.
- context Use proper mounting blotters between a wheel and flanges to take up slight wheel surface roughness when required or supplied by the manufacturer. Do not reuse blotters and only use one blotter for each side of the wheel.
- context Ensure mounting pilot(s) is rounded with length about 2/3 width of the wheel.
- context Extend the threaded section well inside the loose flange.
- context Tighten grinding wheels just enough to prevent them from slipping. Over tightening the spindle nuts or clamping screws can damage the wheel and grinder parts. With multiple screw mounting flanges, tighten the bolts uniformly. Start by barely tightening a screw, "snug-up" opposite screw and, in a crisscross manner, continue until all mounting screws are uniformly tight.
- context Place the threads of the central spindle in the direction that allows the nut to tighten because of the force of the work being done.
- context Ensure all safety guards are in place and properly tightened.
- context Wear appropriate personal protective equipment (e.g., eye protection with side shields/full face shield, respiratory protection, protective clothing such as an apron or long-sleeves and well-fitting gloves, and hearing protectors).
- context Do not wear loose clothing, dangling jewellery and make sure that loose hair is tied back properly.
- context Ensure work area and floor are clean.
- context Before turning on the power, the operator should turn the wheel by hand to check for appropriate wheel clearance.
- context Warn all persons to stay clear of the area where the wheel is used.
- context Stand to one side and test the wheel. Start and run the wheel for at least 1 minute. If any undue vibration occurs, switch off immediately and make adjustments. Never adjust moving machinery.
- context Fact sheet confirmed current: 2023-08-31